3D printing

The Friendly Hill friends, ready to print

Foxy, Oxy, Dragondy and Dinosaury from Friendly Hill, and the Yeti from Yeti mode. Spin them around, then print one in full colour.

Loading…

Drag to spin · pinch to zoom

Foxy

mm, wide × deep × tall
full colour
one colour

Load the AMS like this

Download Foxy for Bambu Studio A .3mf with every colour already in its slot

How to print one

  1. Load the AMS in the slot order above.
  2. Open the figure’s .3mf in Bambu Studio and press the sync button in the Filament list, so it reads the colours in the AMS.
  3. Printer Bambu Lab P1S, 0.4 mm nozzle, Textured PEI plate, 0.16 mm Optimal. Supports off: the figures are shaped not to need them.
  4. Slice, look at the preview, then print. It’s a good overnight print.

The colour changes happen once per layer, not per figure, so two to four of the same friend on one plate take only a little longer than one. Fewer colours print faster: any part can use another slot in Bambu Studio.

The times are estimates. Bambu Studio’s slice gives the real numbers.

All four friends on one plate, in one colour, to paint (.3mf)

They’re chunky, with nothing thinner than about 2 mm, but horns, spikes and ear tips can snap if bent hard. Not for children under 3. PLA softens in a hot car.

Which spools I print them with, and what’s on my shelf: my 3D printing journey.

Foxy, Oxy, Dragondy and Dinosaury: original stories written by Dalai & Travis Hellstrom.

3D models made by Claude from the drawings.